11/18/2023 0 Comments Diy kite string board![]() Using tape, secure the folded edge to the sail.Start on one side and fold the excess plastic over the string of the frame.Place the frame of the kite in the center of the kite sail.Now, you’ll combine your frame with the plastic bag kite sail to finish the main body: ![]() Using your ruler and marker, measure one inch wider than the frame and then trace the shape.If your frame is too large, use a second bag and tape the two sheets of plastic together. Lay the kite frame on the flat sheet of plastic to make sure it fits.Cut the sides of your plastic bag so it becomes a flat sheet.Cut Out the Sail for Your Plastic Bag Kite Repeat the process until the shape is entirely outlined and cut the string from the spool and tie a knot at the same spot you began. Use the string to create a tight line to the end of the next stick. Then wrap the string around the stick a few times. Start by gluing the string to the bottom of the frame. Next, you will use the string to create an outline of the kite around the frame. Place a dot of glue between the two sticks and then wrap the string around the intersection several times ensuring that the sticks meet at a right angle. ![]() Secure the sticks together using the string and glue. The horizontal stick will be about one-third of the way from the top of the vertical stick. Measurements do not need to be exact.Ĭross the smaller stick over the longer stick in the shape of a lower-case T. One stick should be slightly shorter than the other, approximately 4 to 6 inches depending on the size of your kite. Using the sticks and string, build the frame of your DIY kite first. You can also use wooden dowels if you prefer. As you’d imagine, smaller sticks will work better with a smaller bag, whereas longer sticks work best for a garbage bag. They should be similar in size to the plastic bag.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |